Timer symbol
After selecting the suction hood Digit, press the Timer Management Digit to set the countdown.
Grease filter maintenance symbol
The grease filter cleaning signal is displayed by LED and it is always enabled.
Charcoal filter maintenance symbol
The hood is set by default to ducting mode. With no loads on, press the Hood controls digit to
enable the suction hood. Press and hold the Digit again for 5 seconds to:
Activate the charcoal filter:
The charcoal (odour) filter symbol lights up for 1 second.
Deactivate the charcoal filter:
The charcoal (odour) filter symbol flashes twice.
After activation, the icon will light up to indicate that maintenance must be carried out on the
charcoal (odour) filter .
Reset and reactivation of the charcoal filter
After having carried out maintenance on the filter:
- press the button for 5 seconds. - The LED of the grease filter will turn off and the countdown
will restart.
- press the button for 5 seconds. - The LED of the odour filter will turn off and the countdown
will restart.
“9”
Press on the power bar “9” to set the INTENSIVE speed 1. This setting is timed to operate for
10 minutes. Once this time has passed, the system will automatically return to the speed set
previously. It is deactivated by selecting a different speed.
Press twice on the power bar “9” to set the INTENSIVE speed 2. This setting is timed to
operate for 5 minutes. Once this time has passed, the system will automatically return to the
speed set previously. It is deactivated by selecting a different speed.
Delay
This function is only available if Automatic mode is deactivated. Automatic mode is deactivated
by pressing .
Press the suction hood Digit and set a speed on the power bar.
Press the Timer management Digit, which was displaying “CL” but will change to the countdown.
This is pre-set to 15 minutes.
EXTRACTOR CONTROLS
42
To Next Page
Loading...
