Robo-Tank Basic - Page 13

Robo-Tank DIY All-In-One Aquarium Controller User Manual
Robo-Tank DIY All-In-One Aquarium Controller Back to Top User Manual v4.05 – Page 11
On the front and right hand side, are located all the connections for LED lights, various pumps, sensors, and probes.
The primary connectors used are green 4 pin 3.5mm pluggable terminal block connectors, with the exception of the
connections for the Display, and the 8 dosing pumps, which use standard RJ45 connectors.
*4 pin Male Terminal Block Connector
*NOTE: When you buy either the DIY kit or the preassembled kit, you will be provided with 20 male 4 pin terminal block
connectors to wire up your devices
On the front, going left to right, top row:
 Flowmeter 1 and Powerhead 1 and DC Accessory 1
 Flowmeter 2 and Powerhead 2 and DC Accessory 2
 Flowmeter 3 and Powerhead 3 and DC Accessory 3
 Flowmeter 4 and Powerhead 1 and DC Accessory 4
 Sensor 1-2
 Sensor 3-4
 Sensor 5
 Dosing pump 5-8
Left to right, bottom row:
 Atlas-Scientific Circuits