Robo-Tank DIY All-In-One Aquarium Controller User Manual
Robo-Tank DIY All-In-One Aquarium Controller Back to Top User Manual v4.05 – Page 28
Editing the Schedule for Each Daily Light Mode
When you press one of lines, under MODE, in the screen above, you will see a screen similar to the one below.
In this case, the line: was pressed, and you’re editing the transition from High Sun Mid Sun.
Select the time you want the transition to start and
how long you want it to run. On the left the
transition starts at 7:45pm and runs for 1 hour and
15 minutes.
Schedules Sub-Menu Screen
From this screen you have access to set up schedules for lights, power outlets, dosing pumps, the auto-feeder and
powerheads (wave makers).
From the Home screen, press: Settings > Schedules,
and you will get the SCHEDULES screen, to the left.
Lights– This takes you to the light schedules
Power – This takes you to the power schedules
Dosing – This takes you to the dosing schedules
Feeding – This takes you to the feeding schedules
To Next Page
Loading...