Robo-Tank Basic - Sensors and Probes for Controller; Sensor Parameters Screen

Robo-Tank DIY All-In-One Aquarium Controller User Manual
Robo-Tank DIY All-In-One Aquarium Controller Back to Top User Manual v4.05 – Page 47
Sensors and Probes for Controller
The controller can run a combination of 7 Temperature sensors, 4 of which can be set to read a DHT22 or DS18B20 sensor, 2
pH probes, an ORP probe, a DO probe and an EC probe. Using the 5 probes you can read 9 different water parameters. The
controller only works with Atlas-Scientific stamps (circuits).
Sensor Parameters Screen
From the home screen if you press: Sensors, you get
a view of all the sensors and probes connected to
the controller.
If you have the controller set to Celsius the
temperatures are shown that way. This screen
updates every 5 seconds.
You can view the following parameters on this page.
 Water Temperature
 Light Temperature
 Air Temperature
 Temperature 1
 Temperature 2
 Temperature 3
 Temperature 4
 PH
 PH2
 ORP
 Dissolved Oxygen
 Saturation
 Conductivity
 TDS
 Salinity
 Specific Gravity
*NOTE: The blue text is bright and clear on the display