Robo-Tank DIY All-In-One Aquarium Controller User Manual
Robo-Tank DIY All-In-One Aquarium Controller Back to Top User Manual v4.05 – Page 17
Hardware Menu
One thing to remember, most of the changes you make, (95%), will save immediately when you make the change, a few,
save when you leave the page, (but, if for some reason you stay on a screen, after changing a setting, and the screen times
out and returns to the Home screen, it will automatically save the changes unless a power outage occurs before the display
returns to home page automatically). All settings changed are implemented immediately.
From the Home screen, press: Settings > Hardware,
and you will get the HARDWARE SETTINGS screen.
Heaters – Adjust the heater settings
Calibrate Temps – Calibrate main temperature sensors
Dosing Pumps – Calibrate dosing pumps
Powerheads – (coming soon)
Atlas-Scientific Probes – Set up and calibrate Atlas circuits
Custom Rules – Logic settings for sensors
Port Assignment – Here you assign equipment to ports
Flow Meters – Settings for flow meters
*NOTE: The blue text is bright and clear on the display
To Next Page
Loading...