ROBO C2 - Page 32

Robo Support Documentation, Release 0.1.0
2. Next, select ‘Wizards’
3. Select ‘Filament Change Wizard’
4. After you printer heats up, the feeder gear will start to retract the filament from the nozzle
5. Once you see filament coming out of the top of the extuder, select ‘Next’ and ‘Finished’
3.2.3 Start a print
Starting a print from your internal storage
1. Select ‘Files’ from the home screen
2. Select a file you would like to print
3. Now select ‘Start’ to print - and be sure to wait several second while the Robo C2 prepares to print the file
4. Note; you can select ‘Pause’ to pause your print, or you can select ‘Cancel’ to cancel your print
5. Note; you can change the nozzle temperature by pressing on the extruder and adding in your desired
temperture
Starting a print from a USB flash drive
1. Insert the USB flash drive into the usb slot on the front of the printer
2. Select ‘Files’ from the home screen
3. Select which file you would like to print
4. Next, you can choose whether or not you would like to download the file directly to the printer or print
directly from the usb
5. Finally, select ‘Start’ to start the print
3.2.4 Print Status
There are three ways to check on the status of your print while your Robo C2 is at work printing away
Screen
• While your Robo C2 is printing, you can simply check the status by selecting ‘Printer’ on the home screen.
This will indicate the name of the file printing, what percentage done your print is, along with the nozzle
temperature
Robo App
• If you have the Robo App, you can check on the status of your print by selecting the printer under the
‘Dashboard’ tab This will indicate the name of the file printing, what percentage done your print is, along
with the nozzle temperature
Web app
• If you have a web browser on your computer or mobile device, you can check on the status of your print
by navigating to its IP address in the navigation bar of the browser
• To see the IP address of your printer, select ‘Utilities’ from the home screen
• Next select ‘Network’
• Then select ‘IP Address’ and note the IP address of your Robo C2
28 Chapter 3. Logging into your Robo account