ROBO C2 - Maintenance

Robo Support Documentation, Release 0.1.0
– Select which printer you want to print to and tap ‘print’.
3.3.2 Robo C2 touch screen
Navigating the LCD Control Panel
• Files –> File List –> File Info –> Printer
• Printer –> Pause
• Printer –> Cancel
• Printer –> Set extruder temp
• Utilities –> Robo Controls
• Utilities –> Robo Controls
• Utilities –> Wizards –> Z Offset Wizard
• Utilities –> Wizards –> Filament Loading Wizard
• Utilities –> Wizards –> Filament Change Wizard
• Utilities –> Network –> Configure Wifi
• Utilities –> Network –> Start Wifi hotspot
• Utilities –> Network –> Network Status
• Utilities –> Network –> QR Code
• Utilities –> Update
Robo iOS app
3.4 Maintenance
#Robo C2 Maintenance
Remember, a well-maintained Robo C2 is a happy one!
3.4.1 Be sure to check for the following before you print:
• Make sure the print bed is free of any/all objects
• Make sure nothing is blocking the extruder head from moving freely around the build area.
• Make sure no objects are below the print bed that could prevent it from freely moving up and down.
• Make sure there are no broken pieces of filament within the extruder.
• Make sure all cords are neatly tucked away to avoid unnecessary accidents while the printer’s in operation.
• Make sure all of your software is up to date (on screen prompts will let you know when updates are available,
but only if you are connected to a Wi-Fi network).
And to ensure the best 3D printing experience now and in the future, use the following Robo C2 maintenance tips
regularly (every 6-12 months, depending on use):
32 Chapter 3. Logging into your Robo account