Robo Support Documentation, Release 0.1.0
5. Carefully pull the wires by hand to remove them from their housings
6. Place new hotend in by reversing these steps
7. Plug your Robo C2 back in and you are all set
3.5 Safety & Compliance
Before you begin printing, take a look at the following safety precautions.
Radio and television interference This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reposition or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. • Consult
the dealer or an experienced radio/TV technician for help.
You may also find the following FCC booklet helpful: “How to Identify and Resolve Radio-TV Interference Prob-
lems.” This booklet is available from the U.S. Government Printing Office, Washington, D.C. 20402. Changes and
modifications not expressly approved by the manufacturer or registrant of this equipment can void your authority to
operate this equipment under FCC rules.
The following indicate potential safety hazards that could harm you or others or cause product or property damage.
Warning - High temperatures: Robo C2 generates high temperatures. Always allow Robo C2 to cool down before you
reach inside. Warning - Moving parts: Robo C2 includes moving parts that can cause injury. Never reach inside the
Robo C2 while it is in operation.
Warning - Risk of electric shock - There is a risk of shock with Robo C2. This product is not user serviceable.
Warning - Do not leaving the printer unattended: Do not leave the Robo C2 unattended during operation.
Caution - Do not using incorrect / unapproved printing materials: Do not print using materials that have not been
approved by Robo for use with the Robo C2. We highly recommend only using the following when you print:
PLA filament Wood filament Carbon fiber filament
Caution - Use a proper wall socket location: The wall socket outlet must be located near Robo C2 and must be easily
accessible.
Caution - Disconnect from wall socket in case of emergency: In case of emergency disconnect the Robo C2 from the
wall socket.
Caution - Operate Robo C2 in a well-ventilated area: Robo C2 melts plastic during printing. Plastic odors are emitted
during this operation. Make sure to set up Robo C2 in a well ventilated area.
34 Chapter 3. Logging into your Robo account
To Previous Page
Loading...
