20
4.3.3 Setting a Narrow Pass
A Narrow Pass is dened as a path that connects two zones of the lawn. The path enables Robomow to drive
between the zones while following the wire, but prevents the mower from crossing between them while mowing
the inner area of the zones.
To set up a Narrow Pass follow the instructions given in the gure below:
The above setup allows Robomow to drive along the wire to reach the Sub-Zone. However, while mowing each
zone individually, it will not cross over to the other zone.
A. At the point you want the mower to
start driving towards the Sub-Zone
start to set the Narrow Pass.
B. 50 cm (20 inches) from the Narrow
Pass entry, set a Perimeter Island
(refer to 4.2.4) of 30 cm sides (12
inches) at a distance of 10 cm (4
inches) from the Perimeter Wire.
C. Continue to lay the wire towards the
Sub-Zone and lay another Island with
the same dimensions , 50 cm (20
inches) from the Sub-Zone Perimeter
Wire.
D. After completing the setup of the
wire in the Sub-Zone, make sure
you keep 10 cm (4 inches) between
the wire and the islands on the way
back to the Main Zone.
Main Zone
Sub-Zone
Perimeter Island
30x30 cm
Perimeter Island
30x30 cm
To Next Page
Loading...
Need help?
General
