Robomow RM510 - Mowing Quality & Display Issues

49
Problem
Encountered
Probable Cause/Event Corrective/User Action
The Robomow is
noisy and vibrates
- Damaged or unbalanced blade
- Check the lawn is free from branches,
stones or other objects that can damage
the blade before operating the Robomow.
- Replace the blade
- Grass is too high in relation to the set
cutting height
- It is recommended to cut not more than a
1/3 of the green part of the grass.
- Set the cutting height to a higher position
- Use Robomow more frequently to maintain
your lawn.
- Grass is wet
- For best cut, operate Robomow when the
grass is dry. It is recommended to mow
grass early afternoon.
- Dull blade - Replace blade.
- Robomow works too few operations per
week
- Update the weekly program for more
operations per week.
Poor quality of
mowing (grass
clippings are left on
the lawn)
or
Uneven mowing
results
- Working area is too large - Limit the working area
LCD display is in a
foreign language.
- The language setting was changed or
not correctly set.
- Place the mower out of the Base Station
and follow the sequence listed;
- Press ‘STOP’ button few times to confirm it
is on the main display
- Press ‘UP’  button twice
- Press ‘GO’ button once
- Press ‘Down’  arrow button once
- Press ‘GO’ button once
- Press ‘Down’  arrow button 4 times
- Press ‘GO’ button once
- Using the arrow, scroll to the correct
language
- Press ‘GO’ to confirm this selection
- Important! It is possible to see the last 10 battery run times and the battery voltage at
the beginning of the operation in the ‘
Information’ menu (refer to paragraph 2.3.2)
- Battery is not fully charged at the
beginning of the operation
- Confirm the battery icon is fully and not
changed (while charging in the Base
Station) or ‘
Ready keep charging’ message
is displayed (while charging through power
supply) prior the operation.
- ‘Work Time ‘ for that zone is set to
specific time and not to ‘
MAX’
- ‘Work time’ can be changed under ‘Zones
setup’
menu
- Grass is extremely over grown or very
wet.
- Raise cutting height.
- Always mow the grass frequently enough
to prevent over growth.
- CAUTION – Remove battery fuse before
lifting the mower
- Inspect blades for foreign material or
debris preventing rotation.
- Clean out accumulated grass clippings
using a wooden stick.
Short run time,
operates less time
than normal
- Batteries are reaching a normal end of
life state.
- Replace batteries.