Cleaning the Floor Brush
1. Point the Floor Brush icon towards yourself, as shown.
Use a coin to turn the lock 90 degrees clockwise to unlock.
2. Unlock the lock and open the End Cap of the Floor Brush,
then gently slide the roller out.
Roller
Lock
End Cap
Maintenance
Cleaning Rear Filter
* Washing the Rear Filter every two months is recommended
5. When dry, reinstall the filter by aligning it with the unlock
mark, slotting it into the vacuum, then turning clockwise to
lock it in place.
Cleaning the Rollers
Follow these instructions when inspecting and cleaning the
Rollers to ensure optimum performance. Inspection and
cleaning should be performed regularly. Before removing
the roller, remove the accessory from the vacuum to avoid
accidental damage.
Note:
Motorized Mini-Brush and Floor brush rollers must be removed and cleaned
separately. As there are electrical components and bearings in these rollers, do not
wash them with water.
To Next Page
Loading...
