Roborock Q Revo User Manual

13
Removing the battery
The chemical substances contained in the
built-in lithium-ion battery of this product
can cause environmental pollution. Before
disposing of this product, remove the
battery. The battery should then be properly
recycled either through local authorities
or by providing the batteries to a battery
recycling facility.
1. Operate the robot without connecting to
the dock until it runs out of battery.
2. Turn o the robot.
3. Unscrew the battery cover.
4. Remove the battery cover.
5. Press the latch to pull out the battery
connector and remove the battery.
Notes:
•
Before removing the battery, make sure it is fully
drained and the robot is disconnected from the dock.
•
Remove the entire battery pack. Avoid damaging the
battery pack casing to avoid short-circuits or leakage
of hazardous substances.
•
In the event of accidental contact with battery uid,
rinse thoroughly with water and seek immediate
medical care.
Environmental
Protection Description
How to remove the battery:
*
The following information applies only when disposing
of the robot and should not be followed for day-to-day
operations

Roborock Q Revo Specifications

General

Wi-Fi	Yes
Noise level	- dB
Brush material	Rubber
Frequency band	2.4 GHz
Navigation type	Laser Distance Sensor (LDS)
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Water tank capacity	0.08 L
Dust capacity (total)	0.35 L
Base station functions	Charging
Vacuum cleaner programs	Around/along obstacles
Battery life	400 m²
Charging time	4 h
Battery voltage	20 V
Battery capacity	5200 mAh
Package type	Box
Package depth	412 mm
Package width	627 mm
Package height	423 mm
Package weight	15300 g
Shape	Round
Product color	White
Dust container type	-
Suction power	5500 Pa

Weight and Dimensions

Depth	96.5 mm
Width	350 mm
Height	353 mm
Weight	3800 g
Base station weight	8600 g
Base station dimensions (W x D x H)	340 x 487 x 561 mm