EasyManuals Logo

Roborock Q Revo User Manual

Roborock Q Revo
41 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
14
Common Issues
Unable to power on.
The battery level is low. Put the robot on the charging dock and charge it before use.
The battery temperature is too low or too high. Only use the robot within the range of 4-40°C (39-104°F).
Unable to charge.
Check the power indicator light turns on and both ends of the power cabel are properly connected.
If contact is poor, clean the contact areas on the charging dock and the robot.
Slow charging.
When used at high or low temperatures, the robot will automatically reduce its charging speed to extend
battery life.
The charging contacts may be dirty. Wipe them with a dry cloth.
Unable to dock.
There are too many obstacles near the charging dock. Move it to an open area.
The robot is too far from the charging dock. Place it closer and retry.
The dock locator may be dirty. Wipe them with a dry cloth.
Problem Solution
Noise during cleaning.
The main brush, side brush, main wheels, or omni-directional wheel may be jammed. Pause the robot and clean them.
The omnidirectional wheel is jammed. Use a screwdriver to remove it for cleaning.
Unable to connect to WiFi.
WiFi is disabled. Reset the WiFi and try again.
The WiFi signal is poor. Move the robot to an area with good WiFi reception.
Abnormal WiFi connection. Reset the WiFi, download the latest mobile app, and retry.
Unable to connect to WiFi abruptly. There may be an error with your router settings. Contact Roborock
customer service for additional support.
Is power always being drawn when the robot
is on the charging dock?
The robot will draw power while it is docked to maintain battery performance, but power consumption
is minimal.
Does the robot need to be charged for at
least 16 hours the rst three times it is used?
No. The robot can be used any time after it has been fully charged.
Cleaning does not resume
after recharging.
Make sure that the robot is not in DND mode. DND mode will prevent cleanup.
The robot will not resume cleaning if users press
button to recharge or manually place the robot back to the dock.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Roborock Q Revo and is the answer not in the manual?

Roborock Q Revo Specifications

General IconGeneral
Wi-FiYes
Noise level- dB
Brush materialRubber
Frequency band2.4 GHz
Navigation typeLaser Distance Sensor (LDS)
Wi-Fi standards802.11b, 802.11g, Wi-Fi 4 (802.11n)
Water tank capacity0.08 L
Dust capacity (total)0.35 L
Base station functionsCharging
Vacuum cleaner programsAround/along obstacles
Battery life400 m²
Charging time4 h
Battery voltage20 V
Battery capacity5200 mAh
Package typeBox
Package depth412 mm
Package width627 mm
Package height423 mm
Package weight15300 g
ShapeRound
Product colorWhite
Dust container type-
Suction power5500 Pa
Weight and Dimensions IconWeight and Dimensions
Depth96.5 mm
Width350 mm
Height353 mm
Weight3800 g
Base station weight8600 g
Base station dimensions (W x D x H)340 x 487 x 561 mm

Related product manuals