To Next Page

To Previous Page

Instructions for use

On/oﬀ

Note: The robot cannot be turned oﬀ when it is charging.

Start cleanup

Note:

When the robot is cleaning, press any buon to pause it.

Then press the buon to continue cleaning or the buon to stop

the cleanup and send it back to the dock.

Pause

Note: Placing a paused robot on the charging dock manually will end the current cleanup.

If the robot is paused for over 10-minutes, it will go to sleep, and its

power indicator will ﬂash slowly. Press any buon to wake it back up.

Sleep

Note:

Zone 1: Clean Zone 2: Clean

Zone 4: Pending Zone 3: Cleaning

Press and hold the buon to turn on the robot. The power

indicator will turn on, and the robot will enter Standby mode. If the

robot is asleep, press and hold the buon to turn it oﬀ and end

the current cleanup.

Press the buon to start a cleanup. Once started, the robot will

plan its cleaning route based on its scan of the area. It cleans

along the wall of a zone ﬁrst and then moves in a Z-shaped

cleaning route to cover the whole area eﬃciently and thoroughly.

Cleaning cannot start if the baery level is too low. Allow the robot to charge before

restarting cleanup.

Tidy away any cables on the ground (including the power cable of the charging dock)

before cleaning to avoid losing power or damaging either the robot or any connected

devices.

If a cleanup ﬁnishes within 10 minutes, cleaning repeats by default.

If the baery runs low before cleanup is complete, the robot will carry out a top-up charge

before resuming cleanup from where it le oﬀ.

The robot will not go to sleep when it is on the charging dock.

The robot will shut down if le asleep for over 12-hours.

Roborock S4 User Manual

Questions and Answers: