Roborock S6 User Manual

Routine Maintenance
23
Clean the filter
Clean bi-weekly
*
3. Remove the filter and rinse with water.
4. Rinse repeatedly and lightly tap the filter frame against a hard
surface to shake loose any dirt. Continue until clean.
Notes:
Always dry the filter for at least 24-hours before use.
Alternating between two filters is recommended.
5. Dry the filter thoroughly and reinstall.
The product is equipped with a high-performance lithium-ion
rechargeable baery. To maintain optimum baery perfor-
mance, keep the main unit charged.
Baery
Note: If the main unit is to be le unused for a prolonged period of time, power it
off before storage and charge it at least once every 3 months to avoid damaging
the baery through over-discharging.
Clean monthly
*
Use a so dry cloth to clean the charging contacts on the
charging dock.
Charging dock
Side brush
Clean monthly
*
1. Flip the main unit over and remove the screws on the side
brush unit.
2. Remove and clean the side brush.
3. Reinstall the side brush and tighten the screws.
Note: Replacing the side brush every 3-6 months is recommended for maximum
cleaning.

Roborock S6 Specifications

General

Shape	Round
Product color	White
Remotely operated	Yes
Dust container type	Bagless
Noise level	58 dB
Integrated sensors	Accelerometer, Infrared sensor
Number of programs	14
Dust capacity (total)	0.48 L
HEPA filtration system	-
Floor surfaces supported	Carpet, Hard floor
Threshold climbing (max)	20 mm
Battery life	250 m²
Battery capacity	5200 mAh
Power consumption (typical)	58 W

Weight and Dimensions

Depth	350 mm
Width	353 mm
Height	96.5 mm