Roborock S6 User Manual

Routine Maintenance
24
1. Remove the mop cloth from the mopping module.
Ordinary mop cloth Clean aer use
*
Notes:
Always remove the mop cloth for cleaning to avoid dirty water that may block
the filter flowing into the water tank.
If the mop cloth is too dirty, mopping may be affected. Clean it before use.
Changing the mop cloth every 3-6 months is recommended for maximum
cleaning.
2. Clean the mopping cloth and dry it.
Remove and discard used mop cloth, and replace it with a
new one when required.
Disposable mopping cloth
Note: Visit www.roborock.com to purchase additional disposable mop cloths.
1. Pull out the water filters as indicated.
2. Replace with new filters.
Filter assembly
Replace every 1-3 months
*
Note: Replacing filters every 1-3 months is recommended, depending on water
quality and frequency of use, for maximum cleaning.
Omni-directional wheel
Clean monthly
*
1. Flip the main unit over and li up the omni-directional wheel.
2. Remove any trapped hair and dirt on the wheel body and axle.
3. Reinstall the wheel body and press tightly In place.
Wheel body
Axle
Rack
Note: The omni-directional wheel bracket cannot be removed.

Roborock S6 Specifications

General

Shape	Round
Product color	White
Remotely operated	Yes
Dust container type	Bagless
Noise level	58 dB
Integrated sensors	Accelerometer, Infrared sensor
Number of programs	14
Dust capacity (total)	0.48 L
HEPA filtration system	-
Floor surfaces supported	Carpet, Hard floor
Threshold climbing (max)	20 mm
Battery life	250 m²
Battery capacity	5200 mAh
Power consumption (typical)	58 W

Weight and Dimensions

Depth	350 mm
Width	353 mm
Height	96.5 mm