Roborock S7 MaxV Ultra User Manual

015
Basic Parameters
Errors
If an error occurs while the robot is cleaning, the power indicator
will flash red quickly, and a voice alert will sound. Refer to the
following table for troubleshooting.
1. After resolving any of the following errors, relocate your robot and
restart cleaning.
2. After any sensor errors, clean the sensor and retry.
3. If the battery is at an abnormal temperature, wait for it to return
to normal before use.
If the problem persists after using the recommendations in the table above,
please email our after-sales service team:
Europe Support: support@roborock-eu.com
Australia Support: service@roborock.com.au
Note: A system reset may resolve some problems.
Error 1: LiDAR turret or laser blocked. Check for obstruction and
retry.
Error 2: Bumper stuck. Clean it and lightly tap to release it.
Error 3: Wheels suspended. Move robot and restart.
Error 4: Cliff sensor error. Clean cliff sensors, move robot away
from drops and restart.
Error 5: Main brush jammed. Clean main brush and bearings.
Error 6: Side brush jammed. Remove and clean side brush.
Error 7: Wheels jammed. Move the robot and restart.
Error 8: Robot trapped. Clear obstacles surrounding robot.
Error 9: No dustbin. Install dustbin and filter.
Error 12: Low battery. Recharge and retry.
Error 13: Charging error. Clean charging contacts and retry.
Error 14: Battery error.
Error 15: Wall sensor dirty. Clean wall sensor.
Error 16: Robot tilted. Move to level ground and restart.
Error 17: Side brush error. Reset robot.
Error 18: Fan error. Reset robot.
Error 21: Vertical bumper pressed. Move robot and retry.
Error 22: Dock locator error. Clean and retry .
Error 23: Could not return to dock. Clean dock location beacon
and retry.
Error 27: VibraRise system jammed. Check for obstructions.
Error 28: Robot on carpet. Move robot to floor and retry.
Filter blocked or wet. Clean, dry, and retry.
No-go zone or Invisible Wall detected. Move robot from this area.
Cannot cross carpet. Move robot across carpet and restart.
Internal error. Reset the robot.

Roborock S7 MaxV Ultra Specifications

General

Shape	Round
Product color	Black
Number of wheels	3 wheel(s)
Dust container type	-
Smartphone remote support	Yes
Noise level	67 dB
Navigation type	Mapping
Integrated sensors	Camera, Laser
Dust capacity (base)	0.2 L
Dust capacity (total)	- L
Floor surfaces supported	Carpet, Hard floor, Tiles
Dust capacity (vacuum cleaner)	0.4 L
Suction power	5100 Pa
Battery capacity	5200 mAh

Weight and Dimensions

Depth	350 mm
Width	353 mm
Height	96.5 mm