04
Safety Information
WARNING
CAUTION
•
Only use the product in accordance with the User Manual. Any loss or damage caused by improper use will be borne by
the user.
•
Roborock assumes responsibility only for losses resulting from installation performed by authorized Roborock technicians,
excluding losses arising from incorrect installation by other people.
•
Before installing/removing the dock and its pipes, make sure the dock is disconnected from the power source.
•
Make sure dustbin, washable filter, dust bag, side brush, mop cloth, main brushes and main brush cover are installed in
place before cleaning.
•
Do not sit or stand on the robot or dock.
•
To prevent corrosion or damage, do not use any disinfectant and only use cleaning solution recommended by Roborock in
the solution cartridge.
•
Do not put any low objects (such as shoes, mats) near raised areas like stairs. Otherwise, the robot may fall down caused
by malfunctional sensors.
•
To prevent water damage, make sure that the floor where the robot operates is free of water.
•
Place the cords from other appliances out of the area to be cleaned.
•
Do not operate the vacuum in a room where an infant or child is sleeping.
•
For use only with roborock EWFD13LRR or EWFD14LRR charger.
•
To prevent injury caused by blades used to cut hair inside the main brush cover, make sure to install two main brushes in
place before installing the main brush cover.
•
The product must be switched off and the plug must be removed from socket outlet when not in use, before cleaning or
maintaining the product.
•
Connect to a properly grounded outlet only. See Grounding Instructions.
•
Old hose-sets should not be reused. Only use new pipes provided with this product or recommended by Roborock.
•
Place the dock in a dry place. Keep it a distance of more than 1.2m (4 ft) from baths and shower heads or isolate it with
walls or a door to prevent the dock from moisture exposure.
•
Install the dock in compliance with local regulations.
•
Do not move a properly installed dock.
•
Do not rinse the robot and the dock.
To Next Page
Loading...
