10
Accessories
Product Overview
Detergent Drawer
Top Cover
Control Panel
Gasket
Power Plug
Drain Pump Flap
Drain Hose
Drum
Door
Check all accessories shown in the picture above. If the machine is damaged or the
accessories are missing during transportation, please contact the dealer.
Connecting to the App
1. Scan the QR code to download and install the
Roborock app.
2. Open the app, and tap "Scan to Connect" or "+" to
add an appliance.
3. Follow the instructions in the app to complete the
connection.
4. The WiFi (
) lamp is always on, indicating that the
appliance is connected to the network.
Scan to download the APP
Note: Tap and hold the "Rinse" button for 3 seconds to reset WIFI.
User Manual
×1
Transit Bolt
Cover ×4
Noise Reduction
Pad x 4
Wrench ×1Water Inlet
Hose ×1
Installation Requirements
Installation Environment
•
Place the washing machine on a level, rm, and non-slip surface. Do not
install it on a base or shelf.
•
Keep the washing machine in a well-ventilated place away from direct
sunlight and freezing weather.
•
The working environment temperature should be 0°C - 40°C.
•
Keep the washing machine away from heat sources such as charcoal res
or gas stoves.
Top:
≥
25mm
Sides:
≥
25mm
Front:
≥
550mm
Rear:
≥
50mm
25mm
25mm
25mm
Water Supply
Power Supply
•
The washing machine requires a water pressure of 0.1MPa to 1.0MPa.
Water pressure lower than 0.1MPa may cause abnormal water inow. In
this case, the washing machine may not work properly and will display the
prompt [E1].
•
Place the washing machine as close to the faucet as possible; Check the
inlet valve and all connections of the faucet for leakage.
•
Do not connect the washing machine to a hot water source.
•
Connect the washing machine to a power supply (230V~/50Hz) which
should be correctly and reliably grounded.
•
Make sure the power cord is not pinched by any objects.
To Next Page
Loading...
Need help?
General