9
16/01/2020
4) Lower the basket
into place, holding it
by its handles.
Rotate it until it slots
into place.
You can also refer to the label (below) stuck to the
lid.
5) Line the lid up with the notches in the flange
IMPORTANT
Make sure that the pin
on the motor shaft is
correctly lined up with
the corresponding
notch in the basket
hub.
6) Position the pulp container.
7) Close the safety arm.
To start the machine, press the On button 1.
The juicer will not start unless the safety arm has
been closed properly (safety switch).
Place a jug underneath the spout.
Your juicer is now ready to use!
To Next Page
