Robot Coupe J 80 - ASSEMBLY J80

7
16/01/2020
ASSEMBLY J 80
You can also refer to the label (below) stuck to the
lid.
5) Line the lid up with
the notches in the
flange
1) Position the motor
unit so that the On/Off
buttons are facing you.
2) Place the bowl on
top of the motor unit.
4) Lower the basket
into place, holding it
by its handles.
Rotate it until it slots
into place.
3) Fit the flange onto
the rim of the bowl.
The ribs of the flange
should be lined up
with the flat panel of
the bowl. Check that
the flange is correctly
fitted.
Make sure that the pin
on the motor shaft is
correctly lined up with
the corresponding
notch in the basket
hub.
IMPORTANT
FEED TUBE
EJECTOR
GRATING DISC
HANDLES
7
5
4
2
3
1
SIEVE
SAFETY ARM
8
6
14
2
5
3
MOTOR UNIT BASKET
SPOUT LID
FLANGE DRIP TRAY
BOWL PULP CONTAINER
3 7
4 8
2 6
1 5