Robot Coupe MP 450 Ultra - Maintenance and Component Care; Blade, Whisk, and Cord Care

12
• FOOT SEAL
In order to maintain a perfect watertight seal
between the foot and the bell it is necessary to
check the wear of the seal regularly and replace it if
necessary.
• WASHER
The washer can be greased using a suitable food
safe lubricant.
In order to maintain a perfect watertightness it is
necessary to check the wear of the washer, and if
necessary, to replace it.
• CARTRIDGE
You need to change the cartridge :
- If liquid starts seeping into the foot
- If there is any play in the blade
1) Cartridge dismantling :
Position the knife dismantling tool on the
cartridge . Remove the cartridge from its place
by knocking on the knife dismantling tool
with a plastic mallet.
C
D
B
C
W A R N I N G
TECHNICAL SPECIFICATIONS
• WEIGHT & DIMENSIONS (in mm)
From time to time, check:
- The state of the 3 buttons’ watertight mem-
branes. Even the tiniest cracks will allow
liquid to seep in.
- The state of the blender housing. This, should
not show any signs of cracking or any
abnormal openings which could allow access
to the live components.
2) Cartridge mounting :
Direct the ears of
cartridge in order
to be aligned with
the groove of the bell
. Push the cartridge
with the hand in the di-
rection of arrow, then
clip on into the bell
thanks to the knife dis-
mantling tool.
A
B
1 2 3
• POWER CORD:
For your safety, make sure the power cord is always
in good condition. The cord is subjected to conside-
rable wear and tear, and must be replaced if it is da-
maged in any way (cuts, burns, etc.).
Procedure for replacing the power cord:
1) Use the dismantling tool supplied with the new
replacement cord.
2) Press the push button (see photo) and pull on the
cord without releasing the dismantling tool.
2) Installing the new cord:
follow the procedure for OPERATING THE
APPLIANCE (page 6).
1
2