7
The power mixer can
equally be rested
against the rim of the
container, but must be
tilted, and the bell must
not touch the bottom
of the container.
If using a support on top
of the pan, ensure that
the power mixer is
positioned in the centre
of the support, that it is
at a slight angle, and
that the bell is not
touching the bottom of
the container.
Always make sure that the bell is sufficiently immersed
to avoid splashing and that the air vents of the
motor unit does not come into contact with any
liquid.
For optimum efficiency, two thirds of the foot should
be immersed in the preparation.
MP 800 Turbo
An handle which will
help you to have a good
grip and facilitate the
moving of the machine.
• MASHED POTATOES FUNCTION (MP 350 Combi
Ultra, MP 450 Combi Ultra, MP 450 FW Ultra)
A self-regulating speed system has
been specially developped for pu-
reeing tasks using the whisk (jerky
rotation).
To reach this speed, you have to
turn the knob counterclokwise until
you feel a click. Mashed potatoes must be proces-
sed at the lowest speed.
A triangle marked on the speed variation switch
indicates the speed dedicated to mashed potatoes
preparation.
• POWER CORD
After cleaning the machine,
wind the cord around the spe-
cially designed lugs,
without stretching it too much.
This will prolong its lifespan.
WORKING POSITION
• BLADE FUNCTION
For greater control, we
recommend that you hold
the power mixer by the
handle and the bottom of
motor unit. Furthermore, we
recommend that you tilt the
power mixer at a slight
angle to prevent the bell
from touching the bottom of
the container.
• CONTINUOUS OPERATION
(valid for all models)
Follow steps 1 to 6 above, then:
7. While the control button (CB) is in the depressed
position, press the locking button (LB)
8. Release the control button (CB).
9. Release the locking button (LB), and the power
mixer will function continuously.
10. To stop the power mixer, press and release the
control button (CB).
• VARIABLE-SPEED OPERATION
(MP 350 V.V. Ultra, MP 450 V.V. Ultra, MP 350
Combi Ultra, MP 450 Combi Ultra, MP 450 FW
Ultra, MP 450 XL FW Ultra)
Follow steps 1 to 6 above,
then:
7. Change the speed of the
motor by turning the variable
speed button (VB) towards
the maximum or minimum as
required.
Whisk function (MP 350 Combi Ultra, MP 450
Combi Ultra, MP 450 FW Ultra): speed between
250 and 1500 rpm.
Mixer function (MP 350 V.V. Ultra, MP 450 V.V.
Ultra, MP 350 Combi Ultra, MP 450 Combi Ultra):
speed between 1500 and 9000 rpm.
Mixing tool function (MP 450 XL FW Ultra, optional
extra with the MP 350 Combi Ultra and MP 450
Combi Ultra models): speed ranging from 160 to
510 rpm.
It is advisable to start at a low speed when using
the whisk.
Principle of automatic speed regulation : once you
have selected the right speed, leave the mixer to run
on its own. The speed will remain the same, even if
the consistency of the preparation changes.
Power
Mixer on its
pan support
BS
MV
BC
BV
To Next Page
Loading...
