15
• If it is due to overheating of the machine
- Release the control button (CB).
- Unplug the power mixer.
- Wait a few minutes for the motor to cool
down and the thermal safety mechanism to be
reset.
- Restart the power mixer following the paragraph
entitled OPERATING THE APPLIANCE (page 6).
• If you cannot locate the cause of the problem
- Release the control button (CB).
- Unplug the power mixer.
- Check :
- the plug
- that the blades are free to rotate in the bell,
- the state of the power cord,
- that the drive shaft is free to rotate. To do this,
remove the bell and test the rotation of the end of
the drive shaft manually.
• If the intensity warning light flashes
(MP 600 Ultra and MP 800 Turbo)
In case of overload or use
of the mixer in a too sticky
preparation, the intensity
warning flashes for 5 se-
conds to inform you that
the motor will stop shortly.
This stop indicates that the
preparation in process is
too thick or can not be
made with a stick blender.
In this case, you can still restart your mixer.
However, your machine will stop again if the consis-
tency of the preparation is not modified.
Light
If a malfunction occurs which is not on our list of
possible faults, consult your retailer or return the
appliance to the after-sales service.
STANDARDS
Consult the declaration of compliance on page 2.
To Next Page
Loading...
