Protect Your Robot
There are a few important practices you should follow when using
the Avatar® II on a regular basis. Failure to do so may damage your robot.
Before switching/removing payloads on the robot, make sure the robot battery is
unplugged.
Please make sure the battery ejector bar is fully folded (over the top of the battery) before
locking the battery door of robot.
Please use RoboteX-certified batteries ONLY. Other type of batteries might permanently
damage the robot, even they have a similar form factor that will fit inside the unit.
There is ONLY ONE removable antenna on the controller. Please don’t put it on the wrong
port (the correct antenna port is UNCOVERED).
Please make sure that the front flippers are flat when operating the arm. The easiest way
to flatten the flippers is to hold down the flipper control knob until the flippers stop
moving and are positioned flat against the ground.
While loading recorded videos to USB, please don’t unplug the USB stick before the system
finishes downloading files to it.
Please make sure that the 5 metal pads on the battery (shown below) are exposed. If there
is a label covering these pads, please remove it before use. Failure to do so might cause the
robot not to power on reliably.
To Next Page
Loading...
