Robur Direct Digital Controller User Manual

Direct Digital Controller
30 Direct Digital Controller fw 4.013 – Ed. 01/2013
3.3.5 SET DEFAULT PARAMETERS (Technical Assistance Centres only)
The option allows the user to restore, via the DDC, the factory settings memorised on the built-in electronic
board of the machine.
The Direct Digital Controller communicates with the electronic board and receives information regarding the
default parameters (factory settings) set on it (warning: the default parameters are read-only, i.e. cannot be
modified). Via the DDC, the operator may modify some of these parameters and transmit them again to the
machine’s electronic board. The parameters transmitted are used by the board for operation of the unit but this
transmission will have no influence on the default settings memorised on board the machine.
The option is protected by an installer password.
It is not possible to carry out the "set default parameters" operation on third party machines.
NOTE

Robur Direct Digital Controller Specifications

General

Brand	Robur
Model	Direct Digital Controller
Category	Controller
Language	English