Direct Digital Controller
2 Direct Digital Controller fw 4.013 – Ed. 01/2013
1 GENERAL WARNINGS
This manual is an integral and essential part of the product and must be delivered to the end user.
The installation of the Direct Digital Controller must be carried out by professionally qualified
personnel, in compliance with current regulations and according to the manufacturer’s instructions, as
incorrect installation may cause damage to persons, animals or things (or directly to the component), for which
the manufacturer cannot be held responsible.
“Professionally qualified personnel” is defined as those possessing specific technical competence in the sector
of electrical systems.
This device must be used only for the purposes for which it has been expressly designed. Any other use must
be considered inappropriate and therefore dangerous.
The manufacturer is exempt from any contractual or extra-contractual responsibility for damage caused by
errors of installation, use and in any case the non-observance of the instructions supplied by the manufacturer
itself.
In the event of failure and/or poor operation of the Direct Digital Controller, do not attempt to repair it under
any circumstances; any repair must be carried out solely by a ROBUR Technical Assistance Centre, using
only original replacement parts.
The non-observance of the foregoing warnings may compromise the safety of the device.
It is not possible to install the Direct Digital Controller and the GA – GAHP and Prontoclima series of gas
absorption units correctly without consulting the Installation Manual included with the UNIT and the
Installation and Programming Instructions which follow.
To Next Page
Loading...
Need help?
General