Direct Digital Controller
78 Direct Digital Controller fw 4.013 – Ed. 01/2013
It is important ALWAYS to follow this operation during the installation phase of the DDC..
1 Select
from the initial screen to gain access to the main menu.
2 Select
to gain access to the System installation.
3 Enter the installer password, if requested, on the numerical keypad that appears on the display.
4 From the drop-down menu select “DDC”.
5 Select “Ext.temp. filter res. from the drop down menu and press the knob to access the screen.
6 Press F to reset the filter.
7 To exit, select
.
4.4.1.12 Technical assistance information
This option allows the user to set the data regarding the Technical Assistance Centre to contact if necessary
via the information menu (see Paragraph 3.2.4 - “TECHNICAL”).
1 - Select
from the initial screen to gain access to the main menu.
2 - Select
to gain access to the System installation.
3 - Enter the installer password on the numerical keypad that appears on the display.
4 - From the drop-down menu select “DDC”.
5 - Turn the knob to scroll the cursor downwards until “Service Centre Data” is selected and press the knob to
access the screen.
6 - To modify the data that will then be displayed in the information menu (3.2.4 - “TECHNICAL”), turn the
knob to position the cursor on the row to be modified.
7 - Press the knob: a numerical keypad appears that allows up to 18 characters to be entered.
8 - When the text has been entered, select to confirm and exit.
9 - Repeat the operations described above to enter the other two rows.
10 - To exit, select
.
NOTE
To Next Page
Loading...