Direct Digital Controller
Direct Digital Controller fw 4.013 – Ed. 01/2013 81
4.4.1.16 Erase alarms Log (for authorised Technical Assistance Centres only)
Allows the event history to be completely deleted without the need to perform a general DDC reset.
4.4.1.17 Factory defaults
This option allows the user to reset the DDC to its default factory settings. All settable parameters are returned
to their default values.
To carry out a DDC reset, follow the instructions below:
1 - Select
from the initial screen to gain access to the main menu.
2 - Select
to gain access to the System installation.
3 - Enter the installer password on the numerical keypad that appears on the display.
4 - From the drop-down menu select “DDC”.
5 - Turn the knob to scroll the cursor downwards until “Factory defaults” is selected and press the knob to
access the screen.
6 - Select “YES” to confirm the reset, “NO” to return to the drop-down menu.
This function causes also the loss of machine configuration, Multi DDC configuration and event
history.
A short message appears on the screen to confirm that the operation has been performed successfully.
NOTE
To Next Page
Loading...