“For people with diabetes. Use only as directed and see your healthcare professional for medical
advice.”
Accu-Chek Integra is a trademark of Roche. © 2008 Roche Diagnostics
Roche Diagnostics Australia Pty. Ltd
ABN 29 003 001 205
Accu-Chek Enquiry Line 1800 251 816
www.accu-chek.com.au
• If your GLUCOTREND 2 is on, switch it off.
• Gently wipe across test strip guide using a damp non-linting cotton
cloth to remove any traces of blood. Then using your thumb to lift it
gently along its bottom edge, remove the test strip guide carefully.
• Clean the removed test strip guide with cold water and allow it to
dry completely.
• Gently clean the exposed measuring window with a non-linting
cotton cloth or cotton bud.
• Check carefully that test strip guide is completely dry, then re-
insert.
• After cleaning, check the function of your meter using
GLUCOTREND Plus Control G.
• Switch your GLUCOTREND 2 meter OFF.
• Gently press the battery compartment cover upwards with a thumb
to open it, and then fold the cover on its hinges towards you. Do
not try to remove battery cover completely.
• You can now see the twin battery holders. Insert one battery into
each holder, with + upwards.
• Replace the battery compartment lid back over the batteries and
press gently inwards to close it again.
• Press the ON key to check that the batteries are inserted properly.
To Previous Page
Loading...
Need help?
General
