_____________________________________________________________________________________________
© Rocket Espresso Ltd. IT05846260965.Espresso machine mod. R 58. User manual Ed. 03.2012. Subject to change without notice # 16
Refit the correct filter basket into the handle and taste the difference in the flavour
off the coffee. Job well done!
Cleaning other parts of the machine
Switch off the machine and let it cool down. Now proceed to the following cleaning
procedures:
Polish the exterior of your machine with a not abrasive damp cloth rather than a wet
one.
You might use a special cloth to clean stainless steel surfaces. Never clean with
scouring powders or hard implements.
If your machine is connected to the drain, please clean every day the drain reservoir
located under the drip tray (Fig. A/10).
Hot water nozzle and wand: clean with a damp not abrasive cloth.
Clean the water reservoir regularly. To enjoy perfect coffee, we recommend
changing the water every day. Remove the water tank and rinse it with cold water.
Fill the water tank with fresh cold soft drinking water and reinsert.
Never put the tank into a dishwasher!
Steam wand and nozzle
Must be cleaned and burped (to remove milk inside the steam wand) after each use.
Do never allow the milk baking onto the steam wand. How to burp: Open and close
right after the steam handle (Fig. A/2). Hot steam will be dispensed. Caution. Steam
wand and nozzle can become very hot.
Programming your Rocket R 58 espresso machine
Your machine is factory set to optimum working parameters.
Nevertheless you can set your personal parameters using the remote controller (with
display) to be connected to the machine.
You can change the settings of the following parameters:
■ Language
■ Hard plumbing to mains or pour over operation
■ Service boiler heating on or off. The service boiler is the one providing steam and
hot water. If you plan to produce only coffee, you can switch the heating of this
boiler off. So only the coffee water boiler (“brewing head boiler”) will be heated.
■ The coffee water brew boiler’s temperature. It’s factory set to 105°C but you can
set the temperature between 95°C and 115°C. The factory setting of 105°C
reflects to an extraction of around 92°C.
■ The pressure of the service boiler. It’s factory set to 1,1 Bar. It can be changed in
a range in between 0,8 Bar and 1,3 Bar.
To Next Page
Loading...
Need help?
General
