Rocket R 58 User Instructions

_____________________________________________________________________________________________
© Rocket Espresso Ltd. IT05846260965.Espresso machine mod. R 58. User manual Ed. 03.2012. Subject to change without notice # 18
Please proceed as follows to enter programming mode.
1. Keep Key 3 pressed for at least 5 seconds until display reads “Language”.
2. Press Key 1 or key 2 until the display reads the desired language.
3. Press Key 3 to confirm and to move to the next setting which is the
selection of “Water reservoir operation” or “hard plumbing operation”
of the machine.
4. Use Key 1 or Key 2 to program the desired operation and press Key 3 to
confirm and proceed to the next setting which is enabling or disabling the
heating of the hot water/steam boiler (“service boiler”).
5. The display will read “Service boiler heating: off” or “Service boiler
heating: on”. Use Key 1 or Key 2 to program the desired option and
confirm with Key 3. Please note that turning off the heating of the service
boiler means operating only in coffee dispensing mode (using the coffee
brew boiler only).
6. Use Key 1 or Key 2 to program the desired operation and press Key 3 to
confirm and proceed to the next step which is setting the coffee brew
boiler temperature. The factory setting is 105°C. The temperature can be
set within a range from 95°C to 115°C.
7. Use Key 1 or Key 2 to program the desired temperature and press Key 3 to
confirm and proceed to the next step which is setting the service boiler
pressure (hot water/steam boiler). The pressure can be set within a range
of 0.8 Bar to 1.3 Bar. Factory setting is 1.1 Bar.
8. Use Key 1 or Key 2 to program the desired operation and press Key 3 to
confirm. Now the display reads again
Brew boiler
Temperature 105 °C (or the pressure you set)
This is the exit screen.
When the above message is displayed, the machine is no more in programming
mode and can be operated.
Important note: If you’re done with setting the machine at a previous
programming step, please press Key 3 repetitiously until the display reads
Brew boiler
Temperature 105 °C (or the temperature you set)
This is the only way to leave the programming mode and to return to normal
operation of the machine. There is no automatic time out.
Note: Most dual boiler PID espresso machines measure the water temperature used
for the extraction in the brew boiler. The boiler temperature reading is then
converted into a “group extraction” temperature. This information is misleading and
inaccurate, as the digital readout does not display the real temperature at the group
rather the temperature the manufacturer wishes the user to see.

Rocket R 58 Specifications

General

Brand	Rocket
Model	R 58
Category	Coffee Maker
Language	English