8
Indication of LED
Troubleshooting
You can solve your problems from this section
No music out from my stereo speaker
◎ Make sure the RF-BTR319 is powered.
◎ Make sure an audio cable or an Optical cable is correctly and firmly connected to
RF-BTR319
◎ Make sure that the audio source selection of your amplifier is correct with your audio
connection (analogue audio or TOSLINK)
◎ Make sure the volume of the stereo is set to a comfortable listening level
◎ Make sure you are within range.
◎ Make sure the Bluetooth function is opened on your device.
◎ Make sure you are playing the music from your device.
SAFETY WARNINGS
◎ RF-BTR319 requires full connection and both hands to install.
◎ Do not use RF-BTR319near water(for example, a bath tub, wash bowl, kitchen sink, laundry
tub, wet basement, swimming pool, or other areas located near water).
◎ Clean the RF-BTR319 with dry cloth.
◎ Unplug the RF-BTR319 before cleaning.
◎ Installing RF-BTR319 far away from heat sources.
◎ Use only the attached accessories.
◎ Unplug the RF-BTR319 when unused for long time.
***aptX
®
software is copyright CSR plc or its group companies. All rights reserved. The aptX
®
mark and the aptX logo are trademarks of CSR plc or one of its group companies and may be
registered in one or more jurisdictions.
** This device supports Near Field Communication (NFC) technology as specified by the NFC
Forum.
“The N Mark is a trademark or registered trademark of NFC Forum, Inc. in the United States
and in other countries.”
Indication meaning Description
Flash once 1 sec
per 5 secs
Power on
/Pairing
Waiting for connection
Permanent Lighted connected Device and main unit are connected
To Next Page
Loading...
Need help?
General
