RocketFish RF-HTMT15 - STEP 3 - Attach Brackets to TV (Flat Backs); Procedure for Flat Back TVs

9
Need help? Call 1-800-620-2790 (U.S. and Canada)
RF-HTMT15
STEP 3 - Option 1: Attaching the mounting hardware to TVs with a flat
back
1 Align the holes you noted on the TV brackets (B and C) with the screw holes on the back
of your TV. The brackets are marked “R” for the right bracket and “L” for the left bracket.
Make sure that the brackets are level.
2 Place the washers (G or H) over the holes in the TV brackets that align with the screw
holes on the back of your TV, then insert the screws (E, L, M, O, or P) through the washers.
3 Tighten the screws until they are snug against the TV bracket. Do not over tighten.
You’ll need
G (4)
H (4)
E (4)
L (4)
M (4)
Phillips screwdriver
oror
or
Screws
or
O (4)
Washers
Level
(B and C) TV
brackets
or
P (4)
R
L