20
Also, Rocketboost is expandable. Each Rocketboost receiver can
select the audio from any sender in your Rocketboost audio network.
So you can use additional receivers, like the RF-RBREC
receiver/amplifier, RF-RBWHP01 headphones, or the RF-RBWS02
outdoor speaker to listen to music throughout your home.
Connecting the sender
Notes:
Make sure that the sender is located at least 18” from any WiFi router.
The sender supports two audio sources, which are labelled A and B. For each audio
source you can use either the Speaker-In or Pre-in (line level) connectors, depending
on your need. For example, when using the sender with a home theater system
amplifier, it is convenient to use the Speaker-In connectors. When using the sender
with a TV or MP3 player, use the Pre-In connectors.
If you are using the RF-RBKIT for wireless surround sound, your amplifier must
support 5.1 or 7.1 surround sound speaker outputs.
Connecting to the Speaker-In connectors (for home theater
surround sound type connections)
Caution: Turn off your amplifier when connecting the devices.
Note: The diagram and following step are for home theater wireless surround sound. If
you want to listen to your home theater main channels in another room, connect the
left and right channels of the home theater system instead of the surround channels.
To connect the sender to an amplifier:
1 Connect the right surround speaker terminals of your amplifier to the
right speaker terminals of the sender by connecting the red speaker wire
to the red (+) terminals and the black speaker wire to the black (-)
terminals.
RF-RBKIT_10-1157_MAN_V4.fm Page 20 Friday, October 8, 2010 12:53 PM
To Next Page
Loading...
Need help?
General
