25
RF-RBKIT
Using your wireless kit
Turning the sender or receiver on and off
To turn the sender on and off:
1 When initially connecting to an AC outlet, the sender automatically turns
on. To turn off the sender, press . The power indicator turns off and the
standby indicator turns red.
2 If the sender is off, press to turn it on. The power indicator lights.
To turn the receiver on and off:
1 To turn off the device, press . The power indicator turns off and the
standby indicator turns red.
2 If the receiver is off, press to turn it on. The power indicator lights.
Establishing communication
Rocketboost products form an audio network and each Rocketboost
receiver can select the audio from any Rocketboost sender in the
network.
Important
Every Rocketboost network must contain one hub device, which
helps devices join the network. The network can have only one hub,
which you can enable using the hub switch on the back of all
Rocketboost senders and sender/receivers.
If this is your first Rocketboost product, you should make the wireless
sender the hub, if you already have Rocketboost products, you
should disable hub mode on this device.
Important: Hub devices must always have power for your network to operate. The hub
device can be in standby (power saving) mode, but must stay plugged in.
Is this your first Rocketboost product?
YES - If this is your first Rocketboost enabled product, you can skip this
section because your sender and receiver were previously joined or
connected at the factory. To learn how to use your sender and
receiver, see “Listening to music and using your wireless sender and
receiver” on page 29.
RF-RBKIT_10-1157_MAN_V4.fm Page 25 Friday, October 8, 2010 12:53 PM
To Next Page
Loading...
Need help?
General
