26
Note: If you do need to rejoin the sender and receiver, see “Joining the sender to the
receiver” below.
NO - If this is not your first Rocketboost enabled product, proceed to
“Joining the sender and receiver to an existing Rocketboost network”
on page 27.
Joining the sender to the receiver
The sender and receiver must be “joined” or wirelessly connected to
each other, so that audio can be sent from the sender to the receiver.
Note: Use this procedure only if you need to rejoin the sender and receiver and this is
your only Rocketboost-enabled product.
To join the sender and receiver:
1 Set the HUB switch on the sender to ENABLE if this is your first
Rocketboost™ product set.
• The power indicators turn green when the HUB switch is set to ENABLE.
• The power indicators turn blue when the HUB switch is set to DISABLE.
2 Press and hold the button on the sender for more than three seconds
to put it into joining mode. The power indicator starts blinking rapidly
and the unit will stay in joining mode for 30 seconds.
Wireless sender
(HUB: ENABLE)
Other
Rocketboost
devices
Wireless receiver
Power on
indicator
RF-RBKIT_10-1157_MAN_V4.fm Page 26 Friday, October 8, 2010 12:53 PM
To Next Page
Loading...
Need help?
General
