27
RF-RBKIT
3 Press and hold the button on the receiver for more than three seconds
so the sender receiver enter joining mode.
• The power indicators light steadily if the joining was successful.
• The power indicators blink slowly if the joining was not successful.
Note: Rocketboost devices have their own memory. After the devices are joined once,
they will remember each other and join automatically when your devices are
powered on again. Because of this, you can join all of your network components in
the same room before installing them in their permanent locations throughout the
house.
Joining the sender and receiver to an existing Rocketboost
network
Use this procedure only if you are adding this product to an existing
Rocketboost network. You need to join both the sender and receiver
to your existing hub device, using the following steps.
To join an existing Rocketboost network:
1 Set the HUB switch on the sender to DISABLE.
• The power indicators turn green when the HUB switch is set to ENABLE.
• The power indicators turn blue when the HUB switch is set to DISABLE.
2 Press and hold the button on the your Rocketboost Hub device for
more than three seconds to put it into joining mode. The power
indicator starts blinking rapidly and the unit will stay in joining mode for
30 seconds.
3 Press and hold the button on the sender for more than three seconds
so the Hub device and sender enter joining mode.
• The power indicators light steadily if the joining was successful.
• The power indicators blink slowly if the joining was not successful.
Power on
indicator
RF-RBKIT_10-1157_MAN_V4.fm Page 27 Friday, October 8, 2010 12:53 PM
To Next Page
Loading...
Need help?
General
