21
RF-RBUSB
Establishing communication
Rocketboost products form an audio network and each Rocketboost
wireless receiver can select the audio from any Rocketboost wireless
sender in the network.
Important
Every Rocketboost network must contain one hub device, which helps
devices join the network. The network can have only one hub, which
you can enable using the hub switch on the back of all Rocketboost
wireless senders and the wireless sender/receiver.
If this is your first Rocketboost product, you should make the wireless
sender/receiver the hub, if you already have Rocketboost products, you
should disable hub mode on this device.
Important: Hub devices must always have power for your network to
operate. The hub device can be in standby (power saving) mode, but
must stay plugged in.
All Rocketboost devices must be “joined” or wirelessly connected to
your Rocketboost hub device so that audio can be sent between them.
The following steps describe how to join Rocketboost devices.
To establish communications:
1 If you are setting up your network for the first time, choose one of
your Rocketboost wireless senders to be your hub device by setting
the Hub Status switch to Enable. For example, if you want this wireless
sender/receiver to be the hub, set the Hub Status switch on the
wireless sender/receiver to Enable.
2 If you already have a Rocketboost network established, set the Hub
Status switch on this wireless sender/receiver to Disable.
The wireless sender/receiver power indicator lights green if the
wireless sender/receiver Hub Status switch is enabled, or lights blue if
the wireless sender/receiver Hub Status switch is disabled.
3 If possible, bring your Rocketboost hub device, and the new
Rocketboost device to which you’d like to join to the hub, into the
same room.
4 Press the on the Rocketboost hub device to turn it on.
5 Press the on your other Rocketboost device to turn it on.
RF-RBUSB_11-0204_MAN_V1.fm Page 21 Monday, May 2, 2011 8:04 AM
To Next Page
Loading...
Need help?
General
