25
RF-RBWHP01
Specifications
Legal notices
FCC and IC Information:
This device complies with Part 15 of the FCC Rules and RSS-210 of the
IC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user's
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and , if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
Dimensions 9.7 x 8.3 x 4.5 inches (245 x 210 x 114 mm)
Weight 1.3 lbs (0.6 kg)
Frequency response 20 Hz - 20 kHz
THD@1mW 0.2%
Signal to noise ratio 86 dB
Battery life 10 hours
Impedance 32 ohm
Headband Auto-adjusting
Wireless type 2.4 GHz band
Distance 115 feet (35 m) line-of-sight
Speaker input power 20 mW nominal/ 30 mW maximum
RF-RBWHP01_11-0883_MAN_V2.fm Page 25 Tuesday, October 18, 2011 11:04 AM
To Next Page
Loading...
