EasyManua.ls Logo

Rockford Fosgate Power BD1000.1 User Manual

Rockford Fosgate Power BD1000.1
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
mono amplifier
operation & installation
Power bd1500.1
Power bd1000.1
Power bd500.1

Other manuals for Rockford Fosgate Power BD1000.1

Question and Answer IconNeed help?

Do you have a question about the Rockford Fosgate Power BD1000.1 and is the answer not in the manual?

Rockford Fosgate Power BD1000.1 Specifications

General IconGeneral
Number of Channels1
Frequency Response20 Hz - 250 Hz
Signal-to-Noise Ratio> 100 dB
Damping Factor> 200
Remote Punch Level ControlYes
Power Output (RMS) @ 1 Ohm1000 Watts
Rated Power @ 4 Ohms500 Watts
Input Voltage14.4 V
Input Sensitivity150 mV - 4 V
Total Harmonic Distortion (THD)<1.0 %

Summary

Specifications

Introduction

Amplifier Accessory Pack

Lists the items included in the amplifier's accessory pack for installation.

Power Mono Amplifier Feature Chart

Design Features

Terminal Connections

Details speaker, power (B+), ground (GND), and remote (REM) terminals.

Input and Output Features

Covers RCA inputs, Pass-Thru jacks, and the bd Sync cable for connectivity.

Control and Filtering Features

Explains Gain control, Remote Punch Bass, Variable Crossover, and Subsonic Filter.

Indicator Lights

Describes the Power Indicator LED and the Protect LED.

Installation Considerations

Mounting Location

Trunk Mounting

Discusses vertical and floor mounting in the trunk for optimal cooling.

Passenger Compartment Mounting

Covers mounting in the passenger compartment, emphasizing air gap for cooling.

Engine Compartment Mounting

Strongly advises against engine compartment mounting due to warranty voiding and heat issues.

Battery and Charging

Wiring the System

Installation

Power Connections

Illustrates and describes the power wiring connections for the amplifier.

Mono Mode

Shows the rear panel layout for mono operation and notes on RCA inputs and impedance.

Crossover Operation

Variable Crossover

Explains how to set the variable crossover from 50Hz to 250Hz Low-Pass.

Punch Bass Operation

Punch Bass Operation Details

Details the operation of the Punch Bass control, including its adjustment range and precautions.

Pass-Thru

Pass-Thru Functionality

Explains that Pass-Thru provides a signal to a secondary amplifier and remains stereo.

Bridging Mode

Bridging Mode Instructions

Outlines the steps and settings for bridging two amplifiers together for increased power.

Troubleshooting

Proper Connections Check

Guides users on checking power, ground, and remote connections for proper operation.

Audio Output Diagnosis

Provides steps to diagnose issues related to the amplifier's audio output.

Turn-on Pop Solutions

Offers solutions for eliminating the "pop" sound when turning the amplifier on/off.

Engine Noise Resolution

Helps identify and resolve engine noise interference issues in the audio system.

Limited Warranty Information

Warranty Coverage Details

Specifies warranty length, what is covered, who is covered, and exclusions.

Obtaining Service

Provides instructions on how to get warranty service, including contact information and RA#.

Notes

Related product manuals