Need help?Do you have a question about the Rockford Fosgate Punch 150 and is the answer not in the manual?
General| RMS Power at 4 Ohms | 75 Watts x 2 |
|---|---|
| RMS Power at 2 Ohms | 150 Watts x 2 |
| Frequency Response | 20Hz - 20kHz |
| Total Harmonic Distortion (THD) | <0.05% |
| Signal-to-Noise Ratio | > 100 dB |
| Input Sensitivity | 150 mV - 4 V |
| Fuse Rating | 30A |
| Bridged RMS Power at 4 Ohms | 300 Watts |
| Bass Boost | 0dB - 18dB @ 45Hz |
Explains critical safety symbols (Warning/Caution) and provides essential precautions.
Emphasizes disconnecting the battery and following safety rules to prevent damage or injury.
Step-by-step instructions for connecting power, ground, remote, and speaker wires.
Specifies minimum impedance loads (2Ω stereo, 4Ω bridged) for amplifier protection.
Guides on adjusting the input gain for optimal volume and signal-to-noise ratio.
Explains how to set the crossover point for High Pass, All Pass, or Low Pass filtering.
Verifies power, fuses, ground, and voltage for basic operation and connection problems.
Diagnoses audio output problems and methods to eliminate noise interference.
To Next Page