Need help?Do you have a question about the Rockford Fosgate PUNCH 200ix and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Frequency Response | 20Hz - 20kHz |
| THD at Rated RMS Power | < 0.05% |
| Signal to Noise Ratio | > 100 dB |
| Fuse Rating | 30A |
| Bass Boost | 0 - 18 dB |
| RMS Power at 4 Ohms | 50 Watts x 2 |
| RMS Power at 2 Ohms | 100 Watts x 2 |
| Crossover Frequency | 50Hz - 250Hz |
IHF-202 standard dynamic power measurements for various loads.
IASCA standard continuous power ratings for different loads.
Measures the noise level relative to the audio signal.
Provides essential safety rules and wiring best practices for installation.
Offers guidance on drilling safely and ensuring proper chassis grounding.
Details the importance of fusing the power wire and using grommets.
Explains capabilities of bridged mono operation and impedance warnings.
Troubleshoots issues when the amplifier is not playing and the remote light is off.
Troubleshoots issues when the amplifier is not playing but the remote light is on.
Addresses causes and solutions for the amplifier getting too hot.
Provides solutions for unwanted popping noise when the amplifier turns on.
Troubleshoots engine noise or whine affecting the audio signal.
Details the 3-year warranty, exclusions, and limitations.
Outlines the procedure for returning defective products for repair.
To Next Page