Publication 1756-IN001A-US-P - May 2000
Installation Instructions
ControlLogix
Multi-Vendor Interface Module
Catalog Number 1756-MVI
Use this manual as a guide to install the ControlLogix™
Multi-Vendor Interface Module. The following table identifies what
this manual contains and where to find specific information.
Topic See Page
European Communities (EC) Directive Compliance 3
Preventing Electrostatic Discharge 4
Identify Module Components 5
Prepare the Chassis for Module Installation 6
Identify Module Features 6
Set the Configuration Jumpers 7
Determine Module Slot Location 9
Install the Module in the Chassis 10
Remove or Replace the Module (when applicable) 11
Installing or Removing the Module While Power Is Applied 12
Install the Serial Adapter Cables 12
Apply Chassis Power 14
Check Power Supply and Module Status 14
Reading the Status Indicators 15
Perform a Quick Start 16
Connect the Console 16
Configure the Module 16
Test the Module 18
Specifications 19
CUL Hazardous Location Approval 20
To Next Page
Need help?
General
