Publication 1756-RM004B-EN-P - October 2000
Programming the MVI Module 6-7
5. Select Options > Settings and make sure the Truncate unused
image part option is selected, as shown in figure 6.2. Click on
OK.
Figure 6.2 Winimage Settings
6. Select File > Save As, and choose a directory and filename for
the disk image file.
The image must be saved as an uncompressed disk image, so be
sure to select Save as type: Image file (*.IMA) as shown in
figure 6.3. Then click on Save.
Figure 6.3 Save Disk Image
7. Check the disk image file size to be sure it does not exceed the
maximum size of the 1756-MVI module’s ROM disk (896K
bytes). If it is too large, use WINIMAGE to remove files from the
image, then de-fragment the image and try again.
To Next Page
Loading...
