Publication 1756-RM004B-EN-P - October 2000
Programming the MVI Module 6-9
To download a disk image to the 1756-MVI module, follow these
steps:
1. Install the Setup Jumper on the 1756-MVI module. See the
Installation Instructions for details.
2. Connect PRT1 of the 1756-MVI module to your selected port on
the computer using a null-modem serial cable.
3. Using HyperTerm, make sure the MVI module is at the A:/
prompt.
4. Close HyperTerm.
5. Click on the MVI Flash Update icon to start the program.
6. Select the COM port which is connected to PRT1 of the
1756-MVI module. See figure 6.4.
Figure 6.4 MVI Flash Update Connection Dialog
Once a connection to the module has been established, the
Download File dialog shown in figure 6.5 is displayed.
Figure 6.5 MVI Flash Update Download File Dialog
To Next Page
Loading...
