2-2 Start Up
Applying Power to the Drive
❏ 6. Apply AC power and control voltages to the drive.
❏ 7. Familiarize yourself with the integral keypad features (see page 2-3)
before setting any Program Group parameters.
Start, Stop, Direction and Speed Control
Factory default parameter values allow the drive to be controlled from
the integral keypad. No programming is required to start, stop, change
direction and control speed directly from the integral keypad.
Important: To disable reverse operation, see A095 [Re
verse Disable].
If a fault appears on power up, refer to F
ault Descriptions on page 4-3
for an explanation of the fault code.
userman.book Page 2 Friday, June 21, 2002 2:48 PM
To Next Page
Loading...
