Rockwell Automation PanelView Plus 700

141Publication 2711P-UM001I-EN-P - December 2008 141
Chapter 6
Install and Replace Components
Chapter Objectives
This chapter shows how to install, replace, or upgrade various
components of the PanelView Plus terminals.
• Logic module
• RAM and internal CompactFlash
• Communication module
• Display module
• Battery
• Display module bezel
• Backlight
• Product ID label
• Keypad legend inserts
• External CompactFlash card
Required Tools
These tools are required to install and replace components:
• #00, #1, and #2 Phillips screwdriver
• Electrostatic Discharge (ESD) wristband
Precautions
Before installing or replacing any components, disconnect power
from the terminal. During installation, take care not to touch any of
the exposed electronic components.
WARNING
Disconnect all power from the terminal before installing or
replacing any components. Failure to disconnect power may
result in electrical shock or damage to the terminal.
ATTENTION
Be careful when touching any of the exposed electronic
components to prevent damage from electrostatic discharge
(ESD).
Work in a static free environment and wear a properly
grounded ESD wristband.