Need help?Do you have a question about the Rockwell 344-660 and is the answer not in the manual?
Overview of the 10" Homecraft Saw, emphasizing understanding its construction and operation.
General safety precautions and recommendations for using power tools to prevent injury.
Specific safety guidelines for circular saw operations, including guards, work holding, and blade clearance.
Instructions for carefully unpacking the saw and identifying all included loose items.
Visual identification of all loose items packed with the saw, including fence, miter gage, and hardware.
Step-by-step instructions for assembling the saw stand using braces, panels, and feet.
Procedure for attaching the extension wings to the saw table using support bars and screws.
Instructions for mounting the saw onto the assembled stand, including alignment notes.
Instructions on securing the stand or bench to the floor to prevent tipping or movement during operation.
Steps for installing the guide rails on the front and rear of the saw table.
Procedure for assembling the blade guard and splitter assembly to the saw.
Emphasizes proper alignment of the blade guard and splitter to prevent kickback during operation.
Guidance on proper electrical circuit requirements and connecting the saw to the power source.
Detailed guidance on proper electrical connection and grounding of the saw for safety.
Explanation of switch operation, lockout feature, and resetting the motor overload relay.
Instructions for operating and adjusting the rip fence for parallel alignment and rip cuts.
Instructions for operating and adjusting the miter gage for precise angle cuts, including 90 and 45 degrees.
How to adjust the saw blade angle for bevel cuts and set the cutting height.
How to ensure the table insert is flush with the table surface for smooth operation.
Steps to set and verify the saw's 90-degree positive stop for accurate square cuts.
Procedure for safely disconnecting the saw and removing the blade from the arbor.
Information on the combination blade, sharpening, and cleaning of saw blades.
Procedure for removing and replacing the drive belt of the saw.
Guidelines on checking brush life, wear, and replacement for motor longevity.
Instructions on performing cross cuts using the miter gage, including work holding and safety tips.
Guide to making lengthwise cuts using the rip fence, including safety against kickback.
Guide to using the moulding cutterhead for shaping wood edges, including safety precautions.
Instructions for using the dado head set for cutting rabbets and wide grooves.
List of authorized Rockwell service centers for support and repairs.
To Next Page
General