Need help?Do you have a question about the Rockwell 10" Contractors' Saw and is the answer not in the manual?
Rules for safe use, maintenance, and work environment.
Additional safety rules for circular saw operation.
Safe practices for workpiece control, kickbacks, and blade path.
List and illustration of all items included with the saw.
Step-by-step instructions for assembling the stand.
Methods for mounting the saw and securing the stand to the floor.
Instructions for assembling the motor mounting bracket and plate.
Steps to install the motor pulley, V-belt, and guard.
Attaching the belt and pulley guard bracket and cover.
Instructions for installing the switch and securing cords.
Attaching raising/tilting handwheels and lock knobs.
How to attach extension wings to the saw table.
Steps for attaching front and rear guide rails.
Assembling the blade guard and splitter components.
Fine-tuning the splitter for proper alignment with the saw blade.
How to place and level the table insert.
Guidelines for electrical connections, grounding, and extension cords.
Reconnecting motor for 230V operation and plug type.
How to reset the motor's overload protection.
Using handwheels to adjust blade height and tilt angle.
Compensating for wear in the raising mechanism.
Adjusting the blade to ensure a perfect 90-degree stop.
Moving, clamping, and aligning the rip fence.
Adjusting the miter gage for precise angles.
Safe methods for performing cross cuts using the miter gage.
Safe practices for ripping operations with the rip fence.
Using push sticks and fence facing for safe ripping.
Setup and basic use of the moulding cutterhead.
Adding wood facing to the fence for moulding cuts.
How to assemble and use the dado head set.
Listing of basic and additional accessory items for the saw.
Procedure for identifying and ordering replacement parts.
To Next Page
General